×
You seem to have had an issue loading this page or you have javascript disabled, which may cause problems while using Change.org. To avoid any further inconvenience, please enable javascript in your browser and refresh this page.
Implement Cyclic Timetable on Mumbai's local rail network to stop deaths
  • Petitioned Pawan Kumar Bansal , Government of India, New Delhi

This petition was delivered to:

Minister for Railways
Pawan Kumar Bansal , Government of India, New Delhi
Minister of State, Communications & IT and Shipping
Milind Murli Deora
MP
Sanjay Nirupam
MP
Priya Dutt
MP
Gurudas Kamat
MP
Sanjay Dina Patil
MP
Piyush Goyal
MP
Murli Deora
MP
Sanjay Raut
MP
Tariq Anwar
MP
DP Tripathi
MP
Bharatkumar Raut

Implement Cyclic Timetable on Mumbai's local rail network to stop deaths

    1. Samir Zaveri
    2. Petition by

      Samir Zaveri

      Mumbai (Bombay), India

Every day about 10 to 12 people die, while 15-20 gets injured while travelling on Mumbai’s local train network. This all can be stopped with a simple solution of using cyclic timetable that can be implemented without spending a single paisa. With the Rail Budget round the corner, it is the time to make our voices heard by the decision makers and by the Member of Parliaments (MPs) from Mumbai.

After doing research and due diligence for years, septuagenarian Dipak Gandhi, the chairman of Mumbai Suburban Railway Passenger Association (MSRPA), and his colleagues have prepared a cyclic timetable, which can reduce passenger load on each local train by about 30% to 40% and also cut the travel time by 20% to 25% for long-distance commuters. Cyclic timetable also makes it possible to introduce 30% more services with the same number of rakes and tracks through super-fast and sector-wise services.

The suburban railway system in Mumbai is the most complex, densely loaded and intensively utilised system in the world and has the highest passenger density in the world—over 70 lakh commuters travel every day. During 2012, in Mumbai alone, around 3,541 people died while 3,808 were injured in railway accidents. This happens due to overcrowding of the suburban or local trains. Specifically, a twelve-car rake carries over 8,000 passengers against its carrying capacity of 1,800, which leads to unbearably overcrowded trains during peak hours.

ABOUT CYCLIC TIMETABLE
Cyclic timetable as the name suggests is a timetable, which repeats itself after a fixed duration. A key feature of this timetable is that commuters do not have to memorise the whole timetable. All that they need to remember is the cycle time at which a train repeats itself; thus, if the cycle time is 12 minutes then even if someone has missed his train he knows that he will have to wait a maximum of 12 minutes to catch the next train.

This timetable works on four basic principles.

The first principle of CTT states that all the services will have to repeat in a cyclic pattern. In the above table in case of the fast corridor Virar service, after the first service at 17:00 the next will be at 17:12—a gap of 12 minutes. Similarly all the other services will be repeated after a duration of every 12 minutes.

The second principle is Uniform Frequency: this is one of the most important principles on which CTT is based. According to this principle, if the frequency of the train services is uniform it will clearly help to segregate the demand by dividing the commuter traffic evenly in peak hours which is a basic necessity in order to reduce the level of overcrowding and thus the risk of accidents.

The third principle on which CTT works is; Dedicated Sector Wise Clearing as part of which the railway network is divided into various sectors, which are defined on the basis of passenger demand. In any sector a limited number of stations are served and not all the stations overlap or repeat in other sectors. Limited halts ensure that the rakes turn around faster leading to increased services.

Thus, currently, a Virar fast train starts from Churchgate and gets completely filled by the time it reaches Bandra. It then goes on to stop at Andheri and Borivali where there are already a number of people waiting to get in and only a few getting down. This leads to unbearably overcrowded situations and threat to the lives of those who are leaning outside the train. This is a daily pattern.

Cyclical timetable is designed in such a manner that a fast train in the Virar sector would not stop at Andheri and Borivali ensuring that commuters from Churchgate would reach their destinations faster. It would also ensure that the same rake is available faster for a turnaround and can transport more commuters. In this time table commuters of Andheri and Borivali have no choice but to avoid a Virar train. In between stations would be served by other fast and slow services running for other sectors.

The fourth feature of CTT is Limited Loading: A cyclical timetable is made on par with Section (57) of the Railway Act 1989, according to which railway administration shall fix the maximum number of passengers, which may be carried in each compartment. Unlike the current overcrowded conditions CTT emphasises on limited loading by sequencing the services in such a way that it serves few stations with every service thus distributing passenger load evenly, resulting in limited loading.

Traditional approaches of increasing capacity by increasing the number of coaches in rakes have not resulted in significant improvement in the problem of overcrowding. The situation is further aggravated with frequent delays and uneven frequency of trains.

A simple mathematical analysis done by Rajaram Bojji, former managing director of Konkan Railway and inventor of the anti-collision device (ACD) also shows that use of cyclic timetable can reduce the turnaround time for a local train by around 30% as well as waiting period for a commuter.

He said, "A commuter has to wait, skipping a train to board the right one. To some extent, the railway platform may carry a little extra number of passengers. Maybe it is better than crowding the train. There are other factors like percentage failure of signals, track conditions and maintenance speed restrictions, the unauthorised slums crowding the track sides forcing motormen to drive cautiously, which may deny the benefit. However, the idea is worth trying."

Several activists like Samir Zaveri, Dipak Gandhi, Gaurang Damani, Rishi Agarwal and NGOs like Moneylife Foundation and various passenger associations under the banner of "Coalition of Associations & Persons for Safe Rail Travel (CAPSRT)" have been requesting the Railways to follow the cyclic timetable on Mumbai's vast rail network.

The Indian Railways today is in a position to give not only safe but also speedy and comfortable rides to all its commuters from tomorrow, only if it redesigns its suburban timetable in Mumbai as per principles of timetable construction laid down under the Indian Railways Act and its rules—and in conformity with today's traffic needs.

Act NOW. Sign the petition and help Mumbai save 10-12 humans every day!

 

For more information about cyclic timetable click here

 

To:
Pawan Kumar Bansal , Government of India, New Delhi, Minister for Railways
Milind Murli Deora, Minister of State, Communications & IT and Shipping
Sanjay Nirupam, MP
Priya Dutt, MP
Gurudas Kamat, MP
Sanjay Dina Patil, MP
Piyush Goyal, MP
Murli Deora, MP
Sanjay Raut, MP
Tariq Anwar, MP
DP Tripathi, MP
Bharatkumar Raut, MP
Implement Cyclic Timetable on Mumbai's local rail network to stop deaths

Sincerely,
[Your name]

Recent signatures

    News

    1. Info about Cyclic Timetable added

      Samir Zaveri
      Petition Organizer

      As per request from fellow commuters, added the information about cyclic Timetable in the petition. Also there is a link at the bottom that provide more details.
      Thank You.

    2. Thank you

      Samir Zaveri
      Petition Organizer

      Thank you for your support. But we need more signatures. Kindly spread the word. We have over 70 lakh daily commuters and now just need 900. Way to go....

    3. Reached 100 signatures
    4. Stop 10-12 daily deaths on Mumbai’s local trains!

      Samir Zaveri
      Petition Organizer

      The news published by Moneylife

      Sign a petition online to stop 10-12 daily deaths on Mumbai's local trains! - Moneylife

      Every day 10-12 commuters die in Mumbai due to overcrowding in local trains. This can be stopped by implementing cyclic timetable that can reduce passenger load on each local train by about 30% to 40% and also cut the travel time by 20% to 25%.

    5. Reached 50 signatures

    Supporters

    Reasons for signing


    Develop your own tools to win.

    Use the Change.org API to develop your own organizing tools. Find out how to get started.